![]() Try reducing memory overclock of the GPU that frequently trips LHR.Do not delay applying overclock - this will mess up calibration results and the miner will display unrealistically high LHR tune values. ![]() Avoid using RDP if it puts load on your LHR cards. Make sure you don't have monitors connected to your LHR cards, or at least turn them off during miner start up to let it calibrate correctly.Windows - 512.xx (although 472.xx works fine too)Ī few tips if you experience frequent LHR locks: The miner will calibrate the unlocker and the hashrate should go up to its normal level in about a minute after the miner displays calibration finished message. Make sure you remove any -lhr-tune settings you may have in your existing configuration. (Linux) Memory temperature is not displayed on some GDDR6X cards.Change default value of -lhr-autotune-mode parameter to down (used to be full).( ethash) Improve LHR unlock functionality (dual modes and autolykos2 LHR performance is unchanged)Įxpect about 78-79% in normal mode, and 75% in low power mode (see -lhr-low-power). ![]() Watchdog is intended to observe the miner state and restart T-Rex if it crashes. It will not work properly with older drivers. A seamless mining experience enables real-time monitoring of the miner hashrate. IMPORTANT: LHR unlocker requires 512.xx version of the driver on Windows, and 510.xx on Linux.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |